Pepperl+Fuchs
Fotoelektrik Sensörler
OCS2000-M1K-N2
| Etkin algılama menzili | 0 ... 2 m |
|---|---|
| Reflector distance | 100 ... 2000 mm |
| Eşik algılama menzili | 2 m |
| Reference target | Retro-reflector C110-2 |
| Işık kaynağı | LED , 660 nm |
Reflektörlü sensör, NAMUR
- ATEX-, IECEX approval for zone 20 (Dust) and zone 1 (Gas)
- Intrinsically safe, Ex op is ia IIC T6 Gb/IIIC T 135 °C Da
- Glare protected with polarization filter
- ayarlanabilir sensor head
- Scratch resistant mineral glass lens
NAMUR Reflektörlü sensör, special design, 2 m Algılama menzili, kırmızı light, light/dark on, DC versiyon, NAMUR output, terminal compartment, ATEX-, IECEX approval for zone 20 (Dust) and zone 1 (Gas), Intrinsically safe, Ex op is ia IIC T6 Gb/IIIC T 135 °C Da, Glare protected with polarization filter, ayarlanabilir sensor head , Scratch resistant mineral glass lens
OCS2000-M1K-N2
| Etkin algılama menzili | 0 ... 2 m |
|---|---|
| Reflector distance | 100 ... 2000 mm |
| Eşik algılama menzili | 2 m |
| Reference target | Retro-reflector C110-2 |
| Işık kaynağı | LED , 660 nm |
| Işık tipi | modüle görünür kırmızı ışık |
| Polarization filter | var |
| Ortam ışığı limiti | ≤ 10000 Lux sun light · ≤ 7500 Lux halogen light |
| MTTFd | 1319 a |
| Görev süresi (TM) | 20 a |
| Tanı kapsamı (DC) | 0 % |
| Fonksiyon göstergesi | LED sarı: switching state |
| Çalışma gerilimi | 6 ... 20 V DC (Ri yak. 0 Ohm) |
| Ripple | 5 % |
| Time delay before availability | 20 ms |
| Anahtarlama tipi | light/dark on, programmable |
| Sinyal çıkışı | 1 NAMUR output NC/NO programmable |
| Anahtarlama gerilimi | 8 V DC (Ri yak. 1 kΩ) |
| Anahtarlama frekansı | ≤ 100 Hz |
| Reference target detected | Bağlantı 1, 2: ≥ 2.2 m A · Bağlantı 1, 4: ≤ 1 m A |
| Reference target not detected | Bağlantı 1, 2: ≤ 1 m A · Bağlantı 1, 4: ≥ 2.2 m A |
| Tepki süresi | 5 ms |
| Ürün standardı | EN 60947-5-2 |
| Standartlar | EN 60947-5-6:2000 |
| Ortam sıcaklığı | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -40 ... 80 °C (-40 ... 176 °F) |
| Koruma sınıfı | IP20 |
| Bağlantı | M16 terminal compartment, İletken kesiti ≤ 2.5 mm2 |
| Gövde | PBT |
| Optik yüzey | Scratch resistant mineral glass lens |
| Ağırlık | 100 g |
| Yükseklik | 30 mm |
| Genişlik | 30 mm |
| Depth | 102 mm |
| EC-Type Examination Certificate | PTB 01 ATEX 2203 X |
| Applicant | Pepperl+Fuchs Gmb H, Lilienthalstrasse 200, 68307 Mannheim, Germany |
| CE marking | CE0102 |
| ATEX marking | Zone 1: II 2G Ex ia op is IIC T6...T1 Gb |
| Directive conformity | 2014/34/EU |
| Effective internal capacitance Ci | max. 75 n F |
| Effective internal inductance Li | negligibly small |
| General | The apparatus must be operated in accordance with the data provided in the datasheet and this operating instruction. In particular, the maximum rated voltage and the temperature range must be adhered to. The special conditions must be adhered to! The EU-type examination certificate has to be observed. |
| Montaj, commissioning | The associated apparatus must, as a minimum, fulfill the requirements for Koruma sınıfı ia and for Groups II or III, as appropriate for the operating conditions. Due to the possible risk of ignition that can occur as a result of faults and/or transient currents in the equipotential bonding system, galvanic isolation in the supply and signal current circuit is preferred. Associated apparatus without galvanic isolation may only be used if the appropriate requirements as set out in IEC 60079-14 are met. The intrinsic safety is only assured in Bağlantı with an appropriate related apparatus and according to the proof of intrinsic safety. |
| Maintenance | No modifications must be undertaken on apparatus, which is operated in hazardous areas. Repairs to such apparatus are not permissible. |
| Protection from mechanical danger | When used in the temperature range below -20 °C the sensor should be protected from knocks by the provision of an additional Gövde. |
| Koruma sınıfı required when installing connecting components | IP20 according to IEC 60529:2001 |
| Other conditions | Refer to the relevant EC type examination certificate to see the relationship between the connected circuit type, the maximum permitted Ortam sıcaklığı and the temperature class as well as effective inner reactances. |
| Protection against dangerous electrostatic charging | The device must be installed such that electrostatic discharges can be avoided. If the device is installed in accordance with the instructions provided by the manufacturer, no dangerous electrostatic charge is to be expected given the properties of the device. |
| Certificate number | IECEx PTB 12.0060 X |
| IECEx marking | Zone 1: II 2G Ex ia op is IIC T6...T1 Gb |
Doküman henüz eklenmedi.
Bu ürün için stok, termin ve teknik destek bilgisi almak üzere bizimle iletişime geçin.
Adres
Arıkanlar Rota İş Merkezi Yuvaköy Küme Evleri No:31 İç Kapı No:56 Yenimahalle / ANKARA
Telefon
+90 531 699 30 30
E-posta
info@prosenstr.com